Installation Guidelines

Last updated
Save as PDF

This article provides general safety standards and warnings related to installing or connecting a Cloud Services Switch (CSX) 1000 series appliance.

General Safety Guidelines

Caution: Before installing or removing a CSX1000 series appliance, ensure that the appliance chassis is electrically connected to ground. When you are installing or removing an appliance, ensure that you wear an ESD grounding wrist strap. To put the ESD grounding strap on properly, attach it to an ESD point and then place the other end of the strap around your bare wrist, making good skin contact. Failure to use an ESD grounding strap could damage the appliance.

Install the CSX1000 series appliance in compliance with the following local, national, and international electrical codes:
- United States—National Fire Protection Association (NFPA 70), United States National Electrical Code.
- Other countries—International Electromechanical Commission (IEC) 60364, Part 1 through Part 7. Evaluated to the TN power system.
- Canada—Canadian Electrical Code, Part 1, CSA C22.1.
Locate the emergency power-off switch in the installation area. In case of an electrical accident, turn off the power quickly.
Disconnect power to the appliance before installing or removing it.
Disconnect power from the circuit that is being used for the appliance.
If hazardous conditions exist, do not work alone.
If you are working under conditions that might be hazardous to the eyes, wear safety glasses or goggles.

POE and Ethernet Ports Usage

Warning: This equipment is intended for indoor use only and must not be metallically connected to cables routed outdoors.

Avertissement: Cet équipement est destiné à un usage intérieur uniquement et ne doit en aucun cas être connecté électriquement à des câbles installés à l’extérieur.

Electrical Safety Warning on Built-in Power Supply Module

This equipment contains hazardous voltages inside. Servicing and maintenance shall be performed by qualified service personnel only.

Cet équipement contient des tensions dangereuses à l’intérieur. L’entretien et les réparations doivent être effectués uniquement par du personnel qualifié.

Warning: Risk of electric shock. Do not open the enclosure.

Avertissement: Risque de choc électrique. Ne pas ouvrir le boîtier.

Coin Cell Battery

Caution

Risk of fire or explosion if the battery is replaced with an incorrect type. Dispose of used batteries according to the instructions.
Disposal of a battery into ﬁre or a hot oven, or mechanical crushing or cutting of a battery, can result in an explosion.
Leaving a battery in an extremely high temperature environment can result in an explosion or the leakage of ﬂammable liquid or gas.
A battery subjected to extremely low air pressure may result in an explosion or the leakage of ﬂammable liquid or gas.

Attention

Existe riesgo de incendio o explosión si se reemplaza la batería por una de tipo incorrecto. Deseche las baterías usadas de acuerdo con las instrucciones.
La mise au feu d’une batterie ou d’un four chaud, ou l’écrasement ou la coupure mécanique d’une batterie, pouvant entraîner une explosion.
Laisser une batterie dans un environnement ambiant à température extrêmement élevée pouvant entraîner une explosion ou une fuite de liquide ou de gaz inflammables.
Une batterie soumise à une pression d’air extrêmement basse qui peut entraîner une explosion ou la fuite de liquide ou de gaz inflammable.

CE EMC Class A Product Warning

This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate corrective measures.

FCC Interference Statement

This device complies with Part 15 of the Federal Communication Commission (FCC) Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at their own expense.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by using one of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit other than the one to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter.

Radiation Exposure Statement

This equipment complies with CE and FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm (8") between the radiator and your body.

Warning: Operation of this equipment in a residential environment could cause radio interference.

Warning: Operation of this equipment is for indoor use only.